Hydrogen Tap(Electricity Through Magnetic Field ) 100

Back


Electricity Moves over a wire, not through it. In this video I have a picture of "something moving over a field". All power stops but the "Electricity" didn't. Check this out. "THIS IS NOT A SPARK". TELL ME...WHAT IS IT?

Channel: Autos & Vehicles
Uploaded: May 30, 2007 at 7:16 am
Author: johnaarons

Length: 00:06:58
Rating: 0.00
Views: 43088

Tags: hydrogen car meyer energy gas video science

Video Comments:
fgleich (July 7, 2008 at 7:14 am)
It's obviously a loose connection, caused by moving your magnets around. Probably they are oily, or have some residue, or oxidation that is causing this. The spark is jumping out at the horizontal angle because of the powerful magnetic field of those magnets.
Furthermore, voltage doesn't 'stop', it's the current flow that has stopped, because of the incomplete circuit.
I'm not sure about any rectifying effect of the magnet material and the nickel coating ( if so, but it could happen, I suppose.
1980PintoMan (July 2, 2008 at 6:20 am)
Aren't the magnets just acting as a resistor in one direction and not in the other?
streetfightermatt (June 1, 2008 at 2:58 pm)
You are using DC voltage, not AC, that explains the spark.....
prototype9000 (May 28, 2008 at 2:12 pm)
magnets themselves are not conductive thats just the coating on those magnets which is conductive take the coating off with some sandpaper or a knife and try again some magnets though like steel magnets or iron boron magnets are conductive though
rollyrussells (March 30, 2008 at 1:49 am)
two possibilities maby three
one is a static build up in the poly carbonate shell acting like a capacitor
possibility %20
th other is he is building up a lyden response
in electrostatic porportions
possibility %50
tricking us with a van gaf or other electrostatic source %20

other unknown phenomina %10
milannalimm (March 21, 2008 at 2:37 pm)
interesting experiment just please termilogy should be used more correctly ..there is no such thing as voltage go through..current go voltage stays...
NOCNOTCAUGHT (March 17, 2008 at 4:02 am)
Try a continuity tester or ohm meter at each end of the magnets. I suspect the spark is coming from the surface between the magnets where enough arcing has occurred to limit the flow of current. Remember objects fall back to earth because they long to be with the earth not because of gravity.
1freq (March 16, 2008 at 3:56 am)
Read about "Marx Generator".. You are getting an arc due to the air gap between the magnet..I am amazed you are getting that many bubbles using distilled water..
fuckihatesydney (May 26, 2008 at 7:48 am)
he mentions there is lye in the water. if it was distilled water, he wouldn't have had a reading on the second multimeter.
rdavm (February 21, 2008 at 9:25 pm)
Try use a magnet that is that long and its only one, not many together